| 驱动能源 : | 电动执行器 | 型号 : | DCL-100 |
| 品牌 : | 扬州瑞浦 | 加工定制 : | 否 |
| 产品用途 : | 驱动阀门 |
电动执行机构与阀体的安装
Installation of electronic executive bodyand body of valve
电动执行机构与阀体的安装（图5）指正指SHUT处（全闭位置
1．手动转动阀门，检查无异常情况，并使使阀门处于全闭位置。
Rotate the valve manually and make surehave unusnalsituation to check and make the valve in a completely closingposition.
2．将支架固定在阀门上。
详情联系王经理：153，8032，9557（wei 信同号）
Fix the support on valve
3．将联轴器的一端套在阀门芯轴上
Suit an the valve core axle one end ofshaft couping
4．用手柄驱动电动执行机构至全闭位置（指针正指SHUT处零开度刻度线处），将输出轴插入联轴器四方孔内。
Urge electronic executive body to closeposition(indicator
mean with handle shut zero tum on onedegree of scale marks)all, insert the output shaft hen shaft coupling all sidesin the hole
5．坚固支架与电动执行机构和阀体间的连接螺栓。
Connection bolt among firm support and electronicexecutive body and bod of valve
6．用手柄转动执行机构，确认运行平稳、无偏心、无歪斜、检查阀门在执行机构开度计指示范围能否实现全闭和全开
Potete the executive body with the handle,partial, does not have and crooked that confirm operating steadily, Not havingcheck valve turn on degree count, instruct the range will you please realize,close and tum on all in executive
注意：用力不可过猛，否则会导致执行机构超程运行而造成损坏。
Attention: t exerts oneself to be can t tooquickly, otherwise, it wil lead to the fact executive body exceed body Chengrun and cause the damage