Calibration factor 1.11 1.05 1.00 0.94 0.88
同轴电缆(视频线,监控线,射频线)同轴电缆从用途上分可分为基带同轴电缆和宽带同轴电缆(即网络同轴电缆和视频同轴电缆)。
同轴电缆分50Ω基带电缆和75Ω宽带电缆两类。
基带电缆又分细同轴电缆和粗同轴电缆。
基带电缆仅仅用于数字传输,数据率可达10Mbps。
使用特性•工频额定电压U0/U:0.6/1kV。
单芯电缆不允许敷设在磁性管道中。
本产品适用于各种火灾危险较大,消防安全重要性较高场所的电气装备及控制系统作连接线。
一、产品特点及用途耐高温防火控制电缆具有较高的耐火性能,经受火焰直接燃烧下,在一定的时间内不发生短路和断路故障,在火灾发生时,有利于减少损失。
电动葫芦电缆-电动葫芦专用电缆-电动葫芦带丝绳专用电缆使用特性:额定电压:U0/U0.6/1KV及以下最高工作温度:100℃最低环境温度:固定敷设-40℃简单介绍HYA电缆色谱-HYAT电缆色谱-HYAC电缆色谱-以及计算机电缆都采用此标准电缆色谱电缆色谱的详细介绍国际布线标准电缆色谱:主色:白--。

这些都促使机场灯在品种、功能、结构和能耗等方面不断地完善起来。
飞机驾驶员在向着大型机场着陆的过程中,依次看到下列机场灯发出的灯光:①机场灯标。
装在机场内,发出白、绿相间的强烈闪光。
每个机场一个,用以标明机场所在。
1电源线管从地面下穿过时,必须使用套管连接紧密,在地面下不允许有接头,出入地面处必须套用弯头。
地面没有封闭之前,必须保护好PVC套管,不允许有破裂损伤,铺地板砖时PVC套管应被覆盖,钉木地板时,电源线应沿墙角铺设,以防止电源线被钉子损伤。
1电源线走向横平竖直,不可斜拉,防止被电锤、钉子损伤。
各种强弱电插座接口要尽量少。
所有插座、开关要高于地面300MM以上,并且不会被推拉门家俱等物遮挡。
2弱电线路与强电线路不允许共套一管,其间隔距离为0.5m以上。
在缆芯中和屏蔽层的内外表面用石油膏填充或浇注处理,以防止煤矿中水分侵入。
在煤矿常见的32~C一62~C的环境条件下。
用于平巷、斜巷及机电硐室做通信线以及用于平巷,竖井或斜井作主信号传输。
矿用通信电缆结构介绍:1、导线:退火裸铜线,铜线直径为0.30,0.42,0.52,0.60,0.70,0.80,0.90(mm)。
。
后25对是用“白桔”标识线缠着的。
。
。
第二的25对是用“白桔”标识线缠着的。
第三的25对是用“白绿”标识线缠着的。
第四的25对是用“白棕”标识线缠着的。
。
第二的25对是用“白桔”标识线缠着的。
第三的25对是用“白绿”标识线缠着的。
Low smoke and low halogen flame retardant control cables are suitable for the use of ac rated voltage 450/750v and below control, monitoring circuit and protection line with certain environmental protection requirements. Operating conditions (1) rated voltage U0/U is 450/750v; (2) the cable conductor allowed to work at 70 ℃ for a long time; (3) the cable temperature under installation should not below 0 ℃, allowed bending radius; recommended by (4) the cable without armor layer shall be no less than 6 times the outer diameter of the cable; (5) the cable with armored or copper belt shielding structure shall be no less than 12 times the outer diameter of the cable; (6) the soft cable with shield layer structure shall be no less than 6 times of the cable. Technical requirements for 20 ℃ dc resistance conductors shall comply with the terms of GB9330.1 insulation resistance are shown in table 3 - table 6. The fire retardant performance test of the cable conforms to the provisions of GB/T18380. If the user does not require it to meet the requirements of class C fire retardant. The cable smoke concentration shall comply with the provisions of GB/T17651, and its light transmittance shall be 60%. The halogen content should not exceed 100 mg/g. Other performance requirements are the same as GB9330.
Specializing in the production for the telecommunications, computing facilities, instruments and meters connect with wire and cable series product -- -- -- -- -- - RVVP coal RVV series of products: coal mine product logo - logo - Ann Ann symbol certification - coal Ann query - AnBiao query on a coal production license MA for certification to provide coal mine product logo AnBiao certificate, MA certificate, Ann card flame retardant communication cable MHYV MHJYV MHYBV MHYA32 MHYYV MHYY32 flame retardant cable: MHYVR MHYBV MHYV32 MHYVR MHYVP MHYBV MHYVR32 coal mine fire retardant control cable: HYA22 zrc-hya zrc-hyat zrc-hyat23 HYA23 HYA53 HYAT HYAT23 HYAT53 HYAC HJVV HPVV HPVV22 PYV azv HYV22 PYV22 control cable: KVV KVVP kvvv22 kvp2 kvp2 kvp2-22 KVVR KVRP special cable HP KP H Your satisfaction - our unremitting pursuit!

Technical indicators: polyvinyl chloride insulated cables long-term allowed working temperature over 70 ℃, the cable temperature under installation should not below 0 ℃, outer diameter (D) is less than 25 mm cable bending radius is allowed, should not be less than 4 times of cable diameter; The outer diameter (D) shall be the allowable bending radius of 25mm and above cables, and shall not be less than 6 times of the outer diameter of cables.
接地引出线要求采用我镀锡编织铜线,和电缆铜带连接时应用铬铁锡焊,不宜用喷灯封焊,以免烧损绝缘。
③三相铜带屏蔽应分别与地线相连,注意屏蔽接地线和钢铠接地线应分别引出,相互绝缘,焊接地线的位置应尽量靠下。
对电缆端头和中间接头的基本要求:a.导体连接好;b.绝缘可靠,推荐采用辐照交联热收缩型硅橡胶绝缘材料;c.密封良好;d.足够的机械强度,能适应各种运行条件。
上述无刷直流电机结构中有两个死区,即当转子转到N、S极之间的位置为中性点,在此位置霍尔元件感受不到磁场,无输出,则定子绕组也会无电流,电机只能靠惯性转动,如果恰好电动机停在此位置,则会无法启动。
为了克服上述问题,人们在实线中也开发出多种方式。
无刷直流电机的内部结构示意图。
它在泡机中设有三霍尔元件按120分布,转子为单极(N、S)**磁钢,定子绕组为3组,它由6个晶体三极管Ⅴ1~V6驱动各自的绕组,转子位置的检测由两个霍尔元件担任。
使用特性:1、额定电压:交流Uo/U;450/750V2、工作温度:序号1~4-60~+200℃序号5~14-15~+105℃3、绝缘电阻(20℃)不低于50MΩ•km4、导体线芯直流电阻(20℃)符合GB规定5、无铠装电缆允许弯曲半径不小于电缆外径的6倍,铠装电缆允许弯曲半径不小于电缆外径的12倍。
9、低烟无卤阻燃电缆能经受GB12666.5规定的成束燃烧试验且燃烧时的烟浓度符合GB12666.7(IEC1034)的规定,燃烧析出气体水溶液的PH值≥4.3,导电率≤10μs/mm并符合IEC754-2的要求。