(4)固定敷设的低压电缆,应采用Mw铠装或非铠装电缆或对应电压等级的移动橡套软电缆。
(5)非固定敷设的高低压电缆,必须采用符合Mr818标准的橡套软电缆。
移动式和手持式电气设备应使用专用橡套电缆。
(6)照明、通信、信号和控制用的电缆,应采用铠装通信电缆、橡套电缆或M、厂、厂型塑力缆。
电缆的型号:额定电压Uo/U为450/750V或0.6/1KVZR-KVVZR-KVVPZR-KVVP2ZR-KVV22ZR-KVV32ZR-KVVRZR-KVVRPZR-KVVP-22ZR-KVVP2-22ZR-KYJV32ZR-KYJV92ZR-NHKYJV32/92适用范围。
Low smoke and low halogen flame retardant control cables are suitable for the use of ac rated voltage 450/750v and below control, monitoring circuit and protection line with certain environmental protection requirements. Operating conditions (1) rated voltage U0/U is 450/750v; (2) the cable conductor allowed to work at 70 ℃ for a long time; (3) the cable temperature under installation should not below 0 ℃, allowed bending radius; recommended by (4) the cable without armor layer shall be no less than 6 times the outer diameter of the cable; (5) the cable with armored or copper belt shielding structure shall be no less than 12 times the outer diameter of the cable; (6) the soft cable with shield layer structure shall be no less than 6 times of the cable. Technical requirements for 20 ℃ dc resistance conductors shall comply with the terms of GB9330.1 insulation resistance are shown in table 3 - table 6. The fire retardant performance test of the cable conforms to the provisions of GB/T18380. If the user does not require it to meet the requirements of class C fire retardant. The cable smoke concentration shall comply with the provisions of GB/T17651, and its light transmittance shall be 60%. The halogen content should not exceed 100 mg/g. Other performance requirements are the same as GB9330.
3、外导体编织一般60%-80%为宜,偏大对降低衰减效果不是很明显。
4、绝缘生产用的模具设计和加工也是关键,应该保证产品达到较理想的均匀结构,使等效介点常数达到设计要求。
5、物理发泡PE其衰减在低频是合格,而高频(如超过800MHz)时超差,大都与和等效介点常数偏大有关系,或者与外导体编织密度过小,内导体外直径偏小有关系。

RVVSP shielded twisted-pair cable, used in the field lines, electrical instrumentation, telecommunications, broadcasting, anti-theft alarm system, building intercom system, video monitoring system, electronic equipment and automation devices such as shielding line. (transmission RS485 signals /) our factory new micro sales letter, micro signal: 15075619608 QQ is not convenient to micro letter contact! Conditions of use 1: using temperature (℃) : - 40 ~ 60 + 2: relative humidity: 98% at 40 ℃ 3: install the laying temperature is not low, such as: 15 ℃ 4: allowed minimum bending radius: indoor is not less than five times, 10 times outdoor structure 1:2: tinned copper wire line core PVC insulated/twisted-pair cable 3: film around the package/tin copper wire mesh grid block 4 PVC sheathed rated voltage: 300 v / 300 v, 300 v / 300 v with a standard: GB/T5023-1997 RVVP cable series: Can achieve 2 core to 24 core, line diameter has: 0.5, 0.75, 1.0, 1.5, 2.0, 2.5, 4.0, etc. (zr-rvvsp flame retardant),(nh-rvvsp fire resistance),(wdz-rvvsp low smoke halogen free) special model can be produced as required
,一般在长期使用的情况下,电机原本的星形接法**不要改为三角形接法,改为三角形电压必定升高(相电压升高约1.73倍),长时间会烧坏电机。
4,一般长期使用情况下,电机原本的三角形△接法**不要改为星形接法,改为星形电压必定降低,带额定负载时属于过载现象,严重时会烧坏电机。
5,星三角降压启动时,改变接线方式是因为启动时间很短,电流却下降到原来的1/3很明显。
三相异步电动机出厂时候一般都已经接好绕组或者端盖上有接线电路图,严格使用。
煤矿用控制电缆允许的弯曲半径:对有铠装或铜带屏蔽结构的电缆应不小于电缆外径的12倍。
对有屏蔽层结构的软电缆,应不小于电缆外径的6倍。
对无铠装层的电缆应不小于电缆外径的6倍。
产品在全国几十个煤业集团及矿山上使用,获得了较高的评价和赞誉。
3、产品型号规格及范围:产品型号规格范围使用场合MKVV,MKVVP,MKVVP20.5-10mm2,2-61芯适用于弱电控制系统或强电磁场干扰区MKVV22,MKVV200.5-10mm2,4-61芯MKVV32,MKVV300.5-10mm2,7-61芯MKVVR0.5-6mm2,2-61芯MK。
使用条件1:使用温度(℃):-40~+602:相对温度:40℃时达98%3:安装敷设温度不低如:-15℃4:充许最小弯曲半径:室内不小于5倍,室外10倍结构1:镀锡铜丝线芯2:聚氯乙烯绝缘3:薄膜绕包4聚氯乙烯护套额定电压:300V/300V 300V/500V采用标准:GB/T。
每个单位都采用规定色谱的扎带绕带100对及以上电缆加有1%的备用线对,但最多不超过10对;8.缆芯包带:缆芯外包覆非吸湿性、非吸油性的绝缘带;9.电缆屏蔽:用轧纹(或不轧纹)双面涂塑铝带纵包于缆芯包带之外,两边搭接粘合;10.电缆护套:黑色低密度、中密度或高密度聚乙烯;11.识别标记:电缆外表面打印。

MHY32(PUYV39、PUYV39-1)矿用聚乙烯绝缘阻燃聚氯乙烯护套单层钢丝铠装井筒矿用信号电缆用于斜井或竖井中作主信号电缆MHYVRP(PUYVRP)矿用聚乙烯绝缘阻燃聚氯乙烯护套铜丝编织屏蔽软矿用信号电缆用于井下平巷或斜巷作矿用信号电缆MHYVP(PUYVP)矿用聚乙烯绝缘阻燃聚氯乙烯护套。
Purpose: the self-supporting non-filled cable is suitable for the urban and township telecommunication lines of local telecommunication network, and also for the special network lines connecting to the public network. It is economical and practical to use the same outer protective layer for hoisting line and cable. The mechanical and electrical properties of the cable remain unchanged under conditions of 30~C - 60~C. Structure: wire: annealed bare copper wire, copper wire diameter is 0. 4, 0. 50, 0. 60, 0. 70, 0. 80, 0. 90 mm. Insulating material: high density polyethylene or ethylene-propylene copolymer. The color of the insulated wire is in accordance with the full chromatographic standard. Pair of insulated wires: two different colored insulated wires are twisted in pairs according to different pitch and are identified by a specified chromatographic combination. Core structure: with 25 pairs as the basic unit, more than 25 pairs of cables are assembled according to the unit, each unit is wired with the unit of specified chromatogram to identify different units. 100 pairs or more of cables plus 1% of the reserve pair. Core tape: wrap with a polygrease film tape. Shielding: the two sides are overlapped with or without corrugated metal strip, beyond the cable core of the longitudinal capsule. The plastic film coated on the surface of the shielding belt and the bonding sheath of the protective layer: black low density polyethylene. Hoisting line: the hoisting line is 7 strands of galvanized steel strand, nominal outside diameter is 6. 3 and 4 mm. The tensile strength of two types of 75mm is not less than 3000kg and 1800kg respectively. The suspension wire is coated with thermoplastic paint to prevent the steel wire from corrosion. Identification and length marking
下图为带动态惯量阻尼器的步进电机暂态特性的步进响应的比较。
此种吸振阻尼器不会像反相制动方法那样,在产生超调后才制动,但也不会消除最初的超调量。
此种动态惯量阻尼器可以改善步进电机高速区域的共振引起的转矩降低,也可以改善高速时的转矩和响应脉冲。
利用驱动电路的改善半步进1-2相激磁的情况:阻尼以及定位时,利用2相激磁比1相激磁要好。
两相步进电机使用半步进驱动的1-2相激磁时,停止相采用2相激磁,阻尼会变好。
电缆结构:规格型号导体直径绝缘外径编织密度电缆外径SYV1/0.33裸铜1.9mm单层≥80%3.4±0.2mmSYV1/0.33裸铜1.9mm双层≥80%3.9±0.2mmSYV1/0.5裸铜3.0mm单层≥92%5.0±0.2mmSYV7/0.17裸铜3.0m。
销售生产各类煤矿用阻燃通信电缆|煤矿用阻燃通讯电缆|煤矿用阻燃控制电缆|煤矿用信号电缆|矿用通信电缆|矿用通讯电缆|矿用控制电缆|矿用信号电缆|矿用电缆|信号电缆|通讯电缆|通信电缆|煤矿用电缆|市内通信电缆|屏蔽信号电缆|屏蔽控制电缆|铠装通信电缆|充油通信电缆|计算机屏蔽电缆|计算机电缆|煤矿。