HJYVP3ZR/SA成束阻燃型聚乙烯绝缘、聚氯乙烯护套、铝塑复合带绕包总屏蔽组合软结构呼叫通信电缆。
HJYJVZR/SA成束阻燃型交联聚乙烯绝缘、聚氯乙烯护套、组合软结构呼叫通信电缆。
HJYJVPZR/SA成束阻燃型交联聚乙烯绝缘、聚氯乙烯护套、编织总屏蔽组合软结构呼叫通信电缆。
Video transmission usually adopts direct modulation technology and takes the form of baseband (about 8MHz bandwidth). The common transmission medium is coaxial cable. Coaxial cable is specially designed for transmitting video, and its loss, image distortion and image attenuation are all relatively small, which can well complete the task of transmitting video.
The dc resistance of the conductor conforms to GB/T3956
弱电信号线|电话线|铠装电话线；电信局专用电话线；通信电缆-HYA电缆|HYA23电缆|HYA22电缆|HYA53电缆|室外电话线HYA53HYA53钢塑复合带铠装通信电缆;HYA|地面通信电缆|地面通信线缆,直埋市话线.AVVR型300/300V铜芯聚氯乙烯绝AVVR聚氯乙烯软护套线缘聚氯乙烯护套。
The cross section of the control cable is generally no more than 10 square meters, and the power cable is mainly used to transport power, which is generally large. Due to the above all when it comes to the reason, the specifications of the power cable can generally larger, to 500 square feet (normal manufacturer can produce range), again big cross section of the general factory is relatively less, you can do and control cable section generally small, generally not more than 10 largest square, tell from some cable, power cable according to the request of power grid, most commonly for five core, and control cable transmission control signal, some more, according to the standard terms of more than 61 core, but also can produce according to user requirements.
五类网线和六类网线最大的不同在于它们的内部结构和性能。
。
）超五类网线的内部结构只有4对双绞线的铜线。
六类网线在里面结构上增加了十字骨架，主要是为了减少线对间的串扰，达到六类网线标准，大部分的六类网线都是有十字骨架的，少部分能达到六类标准的网线是一字骨架或者没有骨架。
如何通过设备来区分是百兆还是千兆如下图，每个网口都有左右两个绿灯，左边亮表示100M速率，右边亮表示10M的速率，两个都亮表示连接的是1000M的设备。
kvv 2芯*0.75控制电缆 kvv 2芯*1.0控制电缆 kvv 2芯*1.5控制电缆 kvv 3芯*0.75控制电缆 kvv 4芯*0.75控制电缆 kvv 5芯*0.75控制电缆 kvv 6芯*0.75控制电缆 kvv 7芯*0.75控制电缆 kvv 8芯*0.75控制电缆 kvv 10芯。
8 x2x0 DJYVP3R. 75?? 8 x2x1. 0?? Fire retardant computer cable zr-djyvp22; ZR - DJYPV22; ZR - DJYPVP22 DJYVP3R? 1. Use (Q/NPDL 010-2003) this product is suitable for cables with high anti-performance requirements for electronic computer monitoring and is also suitable for cables with high anti-capability requirements for testing instruments and instruments. 2. Performance 1 rated voltage U0/U is 300/500v and below. 2 cable allows - 40 ℃ ~ + 55 ℃ temperature range. In use, the cable should prevent high temperature direct radiation or. 3 cable conductor long-term allowed working temperature is 70 ℃, the temperature under installation should not below 0 ℃. 4. Allowable bending radius of cables: the cable without armor layer shall not be less than 6 times of the outer diameter of cables, and the cable with armor layer shall not be less than 12 times of the outer diameter of cables. Logarithm model the number of nominal section was conductor structure/mm diameter 20 ℃ when the conductor resistance is not greater than Ω/km
RS485 cable product description: Characteristic impedance of 100 ohms, conductor is 2 * 2 * 24 awg multi-strand tin electrolytic copper wire twisted and become, insulating sheath like installation of design and color recognition, overall **** aluminum foil/polyester belt shielding, additional independent stranded tinned copper wire grounding conductor, industrial gray PVC outer sheath, the standard 1 to RS - 485 communication cable, the characteristic impedance of 120 ohms, conductor is 2 * 24 awg stranded tinned copper wire, PE insulation, covered with aluminum foil/polyester composite with **** + 90% tin plated copper wire cover, double shielding with independent grounding conductor is RS - 485 communication cable.
电焊机电缆本产品适用于二次侧对地电压交流不超过200V和脉动直流峰值400V电焊机用二次侧接线及连接电焊钳用。
在一定条件下，也可用于传输2048kbit/s及以上的数字信号。
HYA、HYAT用于架空、管道敷设。
电缆直埋安装时，1-35KV电缆直埋深度不小于0.7m。
10KV及以下电缆平行安装时，相互净距不小于0.1m，10-35KV不小于0.25m；交叉安装时距离不小于0.5m。
电缆敷设温度不低于0℃，弯曲半径：多芯电缆≥15(D+d)，单芯电缆≥20(D+d)，（D为电缆外径，d为导体外径）。
●电缆敷设时环境温度应不低于0℃。
●电缆弯曲半径：三芯电缆不小于电缆外径15倍；单芯电缆不小于电缆外径20倍。
电缆额定电压的选择●电缆的额定电压应适合于电缆系统的运行状况，用Uo/U（Um）KV表示。
Uo--电缆设计用的导体对地或金属屏蔽之间的额定工频电压；U--电缆设计用的导体间的额定工频电压；Um--设备可承受的“最高系统电压”的最大值。
对于直流电路里的继电器，设线圈本身的电阻为R0，在线圈上串联电阻R，电阻旁并联电容C如所示。
当开关K合上时，由于电容的充电电流也要流过线圈，短时间内通过线圈的电流比稳态电流I=U/(R0+R)要大，动作也就加快了。
如果串联电阻R仍按照线圈的额定电流计算，短时间内的实际电流要超过额定值，时间不长，发热并不明显。
继电器加速吸合电路的电源电压应该比不用加速电路时高一些，电阻的散热功率应按稳态电流计算。
基材含卤素的，Z省略。
bZD为成束燃烧D类，适用于外径不大于12mm即较细的产品。
耐火电缆分类在中国普通耐火电缆分为A类和B类：B类电缆能够在750℃～800℃的火焰中和额定电压下耐受燃烧至少90min而电缆不被击穿。
2.电缆耐火防护电缆数量较少时，可用防火涂料、包带加于电缆上或把电缆穿于耐火管。
同一通道中电缆较多时，宜敷设于耐火槽盒内，且对电力电缆宜用透气型式，在无易燃粉尘的环境可用半封闭式，敷设在桥架上的电缆防护区段不长时，也可采用阻火包。
天津市电缆总厂第一分厂物理参数:1.线芯材质:纯铜2.标称对数:5-2400对3.导体直径：铜线直径为、0.40、0.50、0.60、0.70、0.80、0.90mm；4.绝缘材料：高密度聚乙烯；5.绝缘单线：在导线上连续挤制绝缘材料，采用规定的10种标准色谱以便识别，并保证电缆的电气。
DJYPVR 聚乙烯绝缘铜丝编织分屏蔽聚氯乙烯护套软结构电子计算机用电缆。
DJYVPR 聚乙烯绝缘铜丝编织总屏蔽聚氯乙烯护套软结构电子计算机用电缆。
DJYPVPR 聚乙烯绝缘铜丝编织分屏蔽、总屏蔽聚氯乙烯护套软结构电子计算机用电缆。